开发板是mini2440（64M内存），2009年买的，想把它换成最新的系统，按照手册上说的进行默认分区进入bios后按X
##### FriendlyARM BIOS for 2440 #####
[x] bon part 0 320k 2368k
[v] Download vivi
[k] Download linux kernel
[y] Download root_yaffs image
[a] Absolute User Application
[n] Download Nboot
[l] Download WinCE boot-logo
[w] Download WinCE NK.bin
[d] Download & Run
[z] Download zImage into RAM
[g] Boot linux from RAM
[f] Format the nand flash
Boot the system
[s] Set the boot parameters
Backup NAND Flash to HOST through USB(upload)
[r] Restore NAND Flash from HOST through USB
[q] Goto shell of vivi
Enter your selection: x
doing partition
size = 0
size = 327680
size = 2424832
check bad block
part = 0 end = 327680
0: is bad
part = 1 end = 2424832
part = 2 end = 67108864
k = 0 block = 0
part0:
offset = 0
size = 311296
bad_block = 1
0
part1:
offset = 327680
size = 2097152
bad_block = 0
part2:
offset = 2424832
size = 64667648
bad_block = 0
完了之后
按V
用USB进行传输在友善官网上下的supervivi-64M（大小为250KB， 2009版光盘中带的supervivi_mini2440是124KB）
上传时显示这个文件太大，不能上传。后来我改传supervivi_mini2440这个文件后，成功了
想换新系统，得进行重新分区
用户手册说明进入BIOS使用f命令即可，但我键入f命令后提示输入开始地址和结束地址，怎样填写地址？
该分几个区，每个区怎样填写地址才能满足 supervivi-64M（250KB） zImage_N35（2.16M） rootfs_qtopia_qt4.img（84.7M）这套新系统的要求？求解[ 此帖被yijun在2012-05-01 22:40重新编辑 ]
