有没有那位大哥搞定。请出来指教。
我用MINI2440在IAR+JLINK下。好像不能调式
调式信息如下：
Sun May 31 16:36:23 2009: J-Link firmware: V1.20 (J-Link ARM V7 compiled Jan 13 2009 16:38:18)
Sun May 31 16:36:23 2009: JTAG speed is initially set to: 32 kHz
Sun May 31 16:36:23 2009: TotalIRLen = 4, IRPrint = 0x01
Sun May 31 16:36:24 2009: CP15.0.0: 0x41129200: ARM, Architecure 4T
Sun May 31 16:36:24 2009: CP15.0.1: 0x0D172172: ICache: 16kB (64*8*32), DCache: 16kB (64*8*32)
Sun May 31 16:36:24 2009: Cache type: Separate, Write-back, Format A
Sun May 31 16:36:24 2009: Initial reset was performed
Sun May 31 16:36:24 2009: J-Link found 1 JTAG device. ARM core Id: 0032409D(ARM9)
Sun May 31 16:36:24 2009: Device at TAP0 selected
Sun May 31 16:36:24 2009: RTCK is not connected
Sun May 31 16:36:24 2009: Auto JTAG speed: 8000 kHz
Sun May 31 16:36:24 2009: RTCK is not connected
Sun May 31 16:36:24 2009: Auto JTAG speed: 8000 kHz
Sun May 31 16:36:24 2009: 12137 bytes downloaded (23.71 Kbytes/sec)
Sun May 31 16:36:24 2009: Loaded debugee: C:\Documents and Settings\ywy.ZJWSNET\My Documents\ARM\RTC\Debug\Exe\RTC.d79
Sun May 31 16:36:24 2009: TotalIRLen = 4, IRPrint = 0x01
Sun May 31 16:36:24 2009: CP15.0.0: 0x41129200: ARM, Architecure 4T
Sun May 31 16:36:24 2009: CP15.0.1: 0x0D172172: ICache: 16kB (64*8*32), DCache: 16kB (64*8*32)
Sun May 31 16:36:24 2009: Cache type: Separate, Write-back, Format A
Sun May 31 16:36:24 2009: CP15.0.0: 0x41129200: ARM, Architecure 4T
Sun May 31 16:36:24 2009: CP15.0.1: 0x0D172172: ICache: 16kB (64*8*32), DCache: 16kB (64*8*32)
Sun May 31 16:36:24 2009: Cache type: Separate, Write-back, Format A
Sun May 31 16:36:24 2009: Target reset
Sun May 31 16:36:24 2009: Driver does not support code coverage.
不知道是什么问题？？？
