求rtl8187（nw330）固件(firmware)
小弟不才，移植nw330无线网卡就差一步，不能弄到nw330(芯片用的是rtl8187)的固件，而导致整个wifi模块无法完成。调试信息如下，请高手们拍砖指教，如果找不到该固件，不得已必须需要换无线网卡，我应该买哪个型号的无线网卡。请指点
/ #
/ #
/ #
/ # usb 1-1: new full speed USB device using s3c2410-ohci and address 3
usb 1-1: configuration #1 chosen from 1 choice
rtl8187: 8187B chip detected. Support is EXPERIMENTAL, and could damage your
hardware, use at your own risk
phy1: hwaddr 08:10:74:b2:bb:76, RTL8187BvE V0 + rtl8225z2
/ #
/ #
/ #
/ #
/ # iwconfig
lo no wireless extensions.
dummy0 no wireless extensions.
eth0 no wireless extensions.
wmaster0 no wireless extensions.
wlan0 IEEE 802.11bg ESSID:""
Mode:Managed Frequency:2.412 GHz Access Point: Not-Associated
Tx-Power=0 dBm
Retry min limit:7 RTS thr:off Fragment thr=2352 B
Encryption key:off
Power Management:off
Link Quality:0 Signal level:0 Noise level:0
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
/ #
/ #
/ #
/ #
/ # #! /bin/sh
/ # echo "setting the wireless..." > /dev/tty1
iwconfig wlan0 essid "TP-LINK_5CB8A4"
iwconfig wlan0 key loveu
ifconfig wlan0 192.168.1.133
route add default gw 192.168.1.1
echo "nameserver 192.168.1.1" > /etc/resolv.conf
iwconfig wlan0 ap auto
/ # ifconfig wlan0 up
/ # iwconfig wlan0 essid "TP-LINK_5CB8A4"
/ # iwconfig wlan0 key loveu
Error for wireless request "Set Encode" (8B2A) :
invalid argument "loveu".
/ # ifconfig wlan0 192.168.1.133
/ # route add default gw 192.168.1.1
route: SIOCADDRT: File exists
/ # echo "nameserver 192.168.1.1" > /etc/resolv.conf
/ # iwconfig wlan0 ap auto
/ #
/ # ifconfig eth0 down
/ # ifconfig
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:0 (0.0 B) TX bytes:0 (0.0 B)
wlan0 Link encap:Ethernet HWaddr 08:10:74:B2:BB:76
inet addr:192.168.1.133 Bcast:192.168.1.255 Mask:255.255.255.0
UP BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 B) TX bytes:0 (0.0 B)
wmaster0 Link encap:UNSPEC HWaddr 08-10-74-B2-BB-76-00-00-00-00-00-00-00-00-00-00
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 B) TX bytes:0 (0.0 B)
/ #
/ # iwconfig
lo no wireless extensions.
dummy0 no wireless extensions.
eth0 no wireless extensions.
wmaster0 no wireless extensions.
wlan0 IEEE 802.11bg ESSID:"TP-LINK_5CB8A4"
Mode:Managed Frequency:2.412 GHz Access Point: Not-Associated
Tx-Power=27 dBm
Retry min limit:7 RTS thr:off Fragment thr=2352 B
Encryption key:off
Power Management:off
Link Quality:0 Signal level:0 Noise level:0
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
/ #
iwlist scanning可以搜索到网络
/ # iwlist scanning
lo Interface doesn't support scanning.
dummy0 Interface doesn't support scanning.
eth0 Interface doesn't support scanning.
wmaster0 Interface doesn't support scanning.
wlan0 Scan completed :
Cell 01 - Address: 5C:63:BF:44:46:92
ESSID:"TPLINK_16F" Mode:Master
Channel:1
Frequency:2.412 GHz (Channel 1)
Quality=96/100 Signal level:-23 dBm
Encryption key:on
IE: WPA Version 1
Group Cipher : CCMP
Pairwise Ciphers (1) : CCMP
Authentication Suites (1) : PSK
IE: IEEE 802.11i/WPA2 Version 1
Group Cipher : CCMP
Pairwise Ciphers (1) : CCMP
Authentication Suites (1) : PSK
IE: Unknown: 2D1A6E1003FF00000000000000000000000000000000000000000000
Bit Rates:1 Mb/s; 2 Mb/s; 5.5 Mb/s; 11 Mb/s; 6 Mb/s
9 Mb/s; 12 Mb/s; 18 Mb/s; 24 Mb/s; 36 Mb/s
48 Mb/s; 54 Mb/s
Extra:tsf=000000097cf2f180
Extra: Last beacon: 3325ms ago
/ #
[ 此帖被snowboy9859在2012-01-09 20:59重新编辑 ]
